Home   Products   Gallery   Calculators   About Us   Contact Us 
Order Status  |  Shopping Cart  |   Cart Total: $    

Forced PSI Calculators
(THIS IS JUST AN ESTIMATE BASED ON SIMPLE CALCULATIONS!)

Calculate HP from Trap Speed

Vehicle weight in pounds (including driver)
lbs

Trap speed at end of 1/4 mi in m.p.h.
m.p.h.


You are making : HP at the rear wheels and HP at the flywheel*.

*Note:  Assuming a 18% drive train loss.
Calculate HP from ET

Vehicle weight in pounds (including driver)
lbs

ET in seconds
sec


You are making : HP at the rear wheels and HP at the flywheel*.

*Note:  Assuming a 18% drive train loss.

Calculate Tire Diameter
Tire width - Series - Wheel Diameter
Example 275 - 60 R 15
Tire Width
 Tire Series
 Wheel Diameter


Tire diameter in inches



Calculate mph for RPM range
Tire diameter
 Gear Ratio

Forced PSI assumes the car's transmission is in drive or 1:1 ratio, no overdrive. For Overdrive cars mutliply the overdrive ratio times the rear and gear ratio. Example a 700R4 transmission has an overdive ratio 0.7:1. For a 4.11 rear end multiply 4.11 x 0.7 = 2.877. Enter 2.877 as the number for the gear ratio to calculate speeds in overdive.
1000 rpm mph 4500 rpm mph
1500 rpm mph 5000 rpm mph
2000 rpm mph 5500 rpm mph
2500 rpm mph 6000 rpm mph
3000 rpm mph 6500 rpm mph
3500 rpm mph 7000 rpm mph
4000 rpm mph 7500 rpm mph



Calculate Rear End Gear Ratio
Enter the tire diameter in inches, rpm's of the motor at a certain speed as indicated by your speedometer in mph. Forced PSI assumes the car's transmission final drive ratio is 1:1, no overdrive.
Tire Diameter (in)
 RPM
 Speed at RPM (mph)


Rear End Gear Ratio

Accel DFI link Garrett Turbos link Innovative Turbo Systems link Turbonetis Turbochargers Racing link
 
Home | Products | Gallery | Calculators | About Us | Contact Us

Copyright © 2005 ForcedPSI.com

Site Design by SVHDesigns